Optionally you can double check the output for id against the output you saved before. Then log out and log in and it should work from that point. I have run the line in the shell many times, and it does its job. This is the reason for making a copy of the id output to a file, so in case you do mess up at least you know what your user was configured like before. I dont know if its anything special to look after when adding lines to crontab. To add yourself to the dialout group, issue the following command: sudo usermod -a -G dialout $USERĭon't forget the -a flag (for appending groups rather than replacing) or you will have entirely different problems. By default your Arduino is assigned to the group dialout because it registers as a serial interface and in the old days these were often used to. If you look at the output, you'll notice that your user is signed up for several groups and those groups represent extra privileges on the system. Edit the sudoers file (as root) and insert one line to allow the rsync command to run as sudo. This application, based on the command-line utility psync, is designed to allow novice computer users to backup either one part of their hard drive or the entire hard drive to another computer. It is a rsync GUI (Graphical User Interface). Save it in file (not in /tmp as that gets cleaned out on a reboot). For example: export RSYNCCONNECTPROGssh proxyhost nc H 873 rsync -av targethost1::module/src/ /dest/ rsync -av rsync:://targethost2/module/src/ /dest/. Grsync is used to synchronize folders, files and make backups. The easiest solution is to add yourself to the dialout group.įirst make a note of the output from id.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |